Put a new, empty waveform into the selected display (A or B). The waveform currently present there will be hidden and you may access it again via pop-up menus on the right margin of the window.
· Use Waveform Remove waveform to undo.
Remove and delete the selected waveform. Replace it with a first available from the waveform list or a new, empty one.
Set the maximum amplitude of the selected waveform in volts. Calls the same dialog as clicking on the max-amplitude display.
You may only type integer values in the dialog. To adjust decimal digits, use up and down arrows beside the max-amplitude display. One click introduces a change of 0.1V. Alt-click makes the change ten times larger, 1V. Keep pressed to roll the values with accelerating speed.
Join waveforms in the groups in order to control the amplitude simultaneously for all waveforms within the group. The choices are: free, column, row, arbitrary group X, Y, Z. The symbol of the group will be displayed on the left margin of the window, near the lower part of the amplitude axis.
If the current waveform is not the first member of the group, its maximum amplitude will automatically be adjusted to the value defined by the group members.
Max amplitude change of any member of a group propagates to the remaining members.
This command provides an extra security against accidentally increasing the signal amplitude over the allowed value for the device under test. When the program starts, this limit is set by default to 100V (i.e. the maximum).
A single-slope ramp will be automatically created in the selected range of pulses. (Hence, before invoking this command you have to create a desired number of pulses and select them). The ramp may be unipolar or bipolar, rising or falling, the amplitudes and pulse width may be coupled (see Coupling for explanation). The widths of involved pulses will be equal to the value set in the dialog.
Create a sine wave over the selection of pulses. (Hence, before invoking this command you have to create a desired number of pulses and select them). In the dialog you have to state starting angle in degrees, total length in degrees, pulse width and also if you want couplings between pulses.
Create a new waveform exactly the same as the active one. Hide the original waveform and display the copy instead.
Since the new waveform is not associated with any output channel, no additional data will be sent to the generator.
· Use Waveform Remove waveform to undo.