GENERAL-PURPOSE |
|
BROAD-RANGE |
|
||
DC up to 1 MHzlow output impedanceSLEW RATE: up to 300 V/µsThese amplifiers are designed to extend the output range of low voltage signal sources. They are general purpose devices with a very low output impedance and fast response. The output is linear from DC up to megahertz range.
The model program(See MODEL SELECTION CHART as pdf) |
||||
|---|---|---|---|---|
|
x10 ±100V 185mA DC-1MHz single channel |
||||
|
x10 ±100V 185mA DC-1MHz two independent amplifiers |
||||
|
discontinued and replaced by A400DI |
x10 ±100V two independent amplifiers, phase inverter (out 400Vpp differentially) |
|||
|
INV10 |
General purpose phase inverter ±10V -1x |
|||
|
x20 ±150V 150mA DC-1MHz single channel |
||||
|
x20 ±150V 150mA DC-1MHz two independent amplifiers |
||||
|
discontinued and replaced by A400DI |
x20 ±150V two independent amplifiers, phase inverter (out 600Vpp differentially) |
|||
|
F1020 |
x10 ±100V and 20x ±150V independent amplifiers in one case |
|||
|
A400 |
x20 ±200V 150mA DC-1MHz single channel |
|||
|
A400D |
|
x20 ±200V 150mA DC-1MHz two independent amplifiers |
||
|
A400DI |
x20 ±200V 150mA (each channel), bandwith DC-1MHz two independent amplifiers, phase inverter (out 800Vpp differentially) |
|||
|
A400X |
|
x20 ±200V 150mA DC-1MHz two inputs A±B and DC-offset (sum or difference of input signals; inverting mode; non-inverting mode; signal offset) output attenuation -40dB |
||
|
x100 ±300V 75mA DC-200kHz |
||||
|
x100 ±400V 60mA DC-200kHz |
||||
|
|
x100 ±400V 60mA DC-200kHz two independent amplifiers | |||
|
|
x100 ±400V 60mA DC-200kHz two independent amplifiers, phase inverter (out 1600Vpp differentially) | |||
|
x20 (x15 on request) +150V 1A DC-35kHz |
||||
|
x10 ±100V 1A DC-50kHz (available also as x10 ±40V 2A DC-150kHz version on request) |
||||
|
Custom versions available on request. |
The instruments are CE approved |
|||
See also the high current linear amplifiers 
page revised March 9, 2008
